Waring 7011G Manuel d'utilisateur télécharger pdf (Page 2)

Operation

This piece of equipment is designed for the high speed blending,

pulping, mixing or reducing of animal tissue, vegetables, foodstuffs,

plant materials and other substances. A typical operating sequence is

as follows:

1. Add materials to be processed to container.

2. Place cover on container.

3. With the power switch on OFF position, place container on

blender. Be sure container is fully seated and the drive coupling

is properly engaged.

4. Set power switch to ON, Low or High position.

5. When nished processing, set power switch to OFF position.

6. Allow motor to come to a complete stop before removing

container from blender.

Note: Containers with removable bottoms have left-handed threads.

To tighten, turn in direction of molded arrow on underside of removable

bottom. When reassembling, be sure rubber gasket is positioned

between the container and the ange on the blade assembly.

Important

HOT BLENDING INSTRUCTIONS

To minimize possibility of scalding when blending hot materials, the

following precautions and procedures must be observed.

1. Limit amount of material processed to 1/2 pint.

2. Completely remove the center portion of the two-piece container

lid before starting motor. (This will allow venting of the rapidly

heated and expanding air present inside container when blender

is running.)

3. Always start blending lowest speed setting, then progress to

desired speed.

4. Never stand directly over blender when it is being started or while

it is running.

To Operate Timer Model Only

Blender

One Quart Capacity Speciﬁcations

•Ratings 120VAC–50/60Hz–SinglePhase

  230VAC–50Hz–SinglePhase

•Motors Permanentlylubricatedseries-wounduniversaltype

•Timer Selectivetimercyclefrom1to180secondsfor

automatic continuous running

•Bases Zincdiecastingwithepoxyenamelnishorpolished

stainless steel

•Containers Stainlesssteel,borosilicateglass,polycarbonateor

san plastic

•Cord 6foot–18gauge–threeconductorgroundedcordwith

strain relief

Grounding Instructions

• Foryourprotection,WaringCommercialBlendersareequippedwitha

3-conductor cordset.

• 120Voltunitsaresuppliedwithamolded3-pronggrounding-typeplugand

should be used in combination with a properly connected grounding-type

outlet

If a grounding-type outlet is not available, an adapter, shown in Figure 2, may

be obtained to enable a 2-slot wall outlet to be used with a 3-prong plug.

Referring to Figure 3, the adapter must be grounded by attaching its

grounding lug under the screw of the outlet cover plate.

C a u t i o n : Before using an adapter, it must be determined that the outlet cover

plate screw is properly grounded. If in doubt, consult a licensed electrician.

Never use an adapter unless you are sure it is properly grounded.

Note: Use of an adapter is not permitted in Canada.

Green/Yellow: Earth Ground Blue: Neutral Brown: Live

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Waring 7011G Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Mixeurs Waring 7011G